How to use?

1. Open the box and take out a bag.
2. Unfold the bag, place the insert at the bottom of the bag and roll up the bag to fit through the neck of the container.
   Advice: place a maximum of 1 extra insert to increase the absorption capacity,
3. Place the rolled up bag through the neck of the holder, the bag will unroll into the bottom of the holder. If necessary, reposition the insert by moving the insert via the back of the holder.
4. Place the bag around the neck of the holder with the strings on both sides. Place the strings crosswise behind the attachment point located on the neck of the holder. Pull the bag tight through the back of the holder so that the strings are around the attachment point on the neck (In the case of stick test/sampling before cultivation, add the insert afterwards).
   
5. Urinate in the bag.
6. Wait for some time until the insert has turned into gel.
7. Detach the bag from the holder (loosen the strings and remove the bag at the bottom).
8. Close the bag by pulling the drawstring and button the bag both on top of the bag and with an extra button around the neck of the bag.
9. Dispose of the bag with the residual waste or in accordance with the institution's waste policy.
10. After removing the used bag, clean the holder domestically, disinfect it if necessary in case of visible contamination and place a new bag in the holder so that it is ready for next use.
11. Place the holder back in the place where it normally lies or hangs.
12. Discard the container:
    - if, despite (repeated) manual cleaning and disinfection, the container remains visibly soiled or contains limescale deposits;
    - if it is damaged;
    - when the client-related status is lifted.